Steel Sheet Piling is an effective earth retention and excavation support construction material, Used worldwide for the construction of quays walls and breakwaters in harbours, locks, and for bank reinforcement on rivers and canals.

Material:Q235B,Q345B,S235,S240,SY295,S355,S430,S460,A690,ASTM A572 Grade 50,ASTM A572 Grade 60.All Chinese Standard, EN Standard, ASTM Standard and other standard material are available on request.

Manufacturing Inspection Standard:EN10249-1 EN10249-2.

Hot Rolled Sheet Piles

Hot Rolled Sheet Piles are formed by profiling the steel with high temperatures as the rolling process occurs. Typically, hot rolled sheet piles are produced to BS EN 10248 Part 1 & 2. Greater thicknesses are achievable than cold rolled sheet piles. The interlocking clutch tends to be tighter as well.

Cold Formed & Cold Rolled Sheet Piles

Cold Rolling and Forming processes are when the steel sheet pile is profiled at room temperature. The profile thickness is constant along the width of the profile. Typically, cold rolled/formed sheet piles are produced to BS EN 10249 Part 1 & 2. Cold Rolling occurs in a continuous section from hot rolled coil whereas Cold Forming occurs is discrete lengths either from decoiled hot rolled coil or plate. A wide range of widths and depths are achievable.

Applications

Steel sheet piles are used worldwide for the construction of quays walls and breakwaters in harbours, locks, and for bank reinforcement on rivers and canals. Other applications are temporary cofferdams in land and in water, permanent bridge abutments, retaining walls for underpasses or underground car parks, impervious containment walls, etc.

Common product types

Hat-type sheet piles

Super drivability

The large sectional area of the Hat-type sheet pile realizes superior drivability.

High structural reliability

No reduction is required in sectional properties to consider the possible lack of shear force transmission at the interlocks, which is true for U-type steel sheet piles.

Excellent cost-effectiveness

The amount of steel per unit wall can be reduced, resulting in improved total cost.

U-type sheet piles 

U-type sections have been widely used for various types of permanent and temporary structures, and are one of the most familiar sheet piles among both designers and users.

NS-SP-Ⅱ,Ⅲ,ⅢA,Ⅳ,ⅤL and ⅥL are solidly designed. These sections are especially suitable for repeated use, and have acquired high market acceptance from users.

U-type sections offer section modulus ranging from 874 cm3/m to 3,820 cm3/m.

Hot Rolled Sheet Pile

ZZL has one of the widest ranges of steel sheet piles for sale: with over 15 series' and over 400 profiles in hot rolled sheet piles, cold rolled sheet piles and cold formed sheet piles in assortment of steel grades and production standards.

Quote For The Best Materials Today!